Glock Talk banner
1 - 2 of 2 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hello Everyone..., had a concern and figured this would be the best place for feedback!! I recently replace my Gen 3 G23 connector with a LW 3.5. Everything went well but I noticed that when I replace the slide the connector protrusion slightly catches the slide.., not much and it's easy to push over and on....or I can slighty lift the slide (just a hair) and it goes on without catching. The weapon fires flawlessly..., the original connector did not have this "catch" and was just curious if this was an issue or ok?

Thanks

Steven
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top