close

Privacy guaranteed - Your email is not shared with anyone.

10mm/40 dies

Discussion in 'Reloading' started by malcarjeb, Jan 13, 2010.

  1. malcarjeb

    malcarjeb

    Messages:
    2
    Likes Received:
    0
    Joined:
    Jan 9, 2010
    I'm sure this has been asked before but I can't find it-- Can you use redding 10mm dies to load the 40sw? The dies in question is Redding part num. 88520

    Thanks
     
  2. IndyGunFreak

    IndyGunFreak

    Messages:
    26,840
    Likes Received:
    2,205
    Joined:
    Jan 26, 2001
    Location:
    Indiana
    Most of the time, yes. Those for whatever reason, are specifically marked 10mm, then they also have a 10mm/40 set(88253)... This would lead me to believe that for some reason, your dies are 10mm only... That's just a guess though.

    IGF
     

  3. shotgunred

    shotgunred local trouble maker

    Messages:
    9,125
    Likes Received:
    1,401
    Joined:
    Mar 1, 2008
    Location:
    Washington (the state)
    You have to readjust them. well the last two at least.
     
  4. G10mm

    G10mm

    Messages:
    374
    Likes Received:
    3
    Joined:
    Jan 23, 2007
    Location:
    Pa


    If these are the dies I am thinking about they are size the hole case all the way down to the bottom of the case . If you shot Glock brass threw other guns this is the die you need . I would call redding up and ask them . After all
    they made . Trying to navagate there web site sucks big time .:cool:
     
  5. Colorado4Wheel

    Colorado4Wheel

    Messages:
    14,993
    Likes Received:
    221
    Joined:
    Nov 2, 2006
    Location:
    CO
    10mm sizing die will size .40 all the way down.
     
  6. malcarjeb

    malcarjeb

    Messages:
    2
    Likes Received:
    0
    Joined:
    Jan 9, 2010
    Got the Dies to day and they say on them: 40sw/10mm so must be good for both. Thanks