Privacy guaranteed - Your email is not shared with anyone.
Separate names with a comma.
Discussion in '1911 Forums' started by Quack, May 31, 2012.
remove the elevation screw:
lift BoMar leaf up.
Loosen set screw:
use a sight pusher to center the base to make sure the leaf fits in the cut out.
loctite the set screws
wipe off excess loctite
install leaf, loctite the screw and tighten.
Very nice. Looking to get one myself. Nice write up.
Very nice. nice write up too. thanks.
I've grown to like the sight picture of the 10-8 rear sight.
Very nice, well done Quack
Looks great Don.
Hell of an improvement!
now you'd ruin a perfectly good gun. LOL.
Much better than the stock sight.
Oh, by the way Don you have enough locktite on the one screw for ten of them.