Left over new factory Glock parts from when I closed my gun shop in 2012. I was a Glock Stocking dealer and found a few new factory Glock parts. Here is your chance to buy a few parts at pre panic pricing.
Recoil Spring Assembly for Gen 3 Models 19,23,32
Trigger Housing with Ejector for gen 4...
I noticed some slide wear on my Gen 5 Glock 19 from either the trigger connector, or the fin on the trigger bar whenever I field strip the gun (the side of the trigger fin rubs against it but I rarely field strip it). I have 1000 rounds put through it. Just wondering if it was normal.
Recently I got a strike 80, drilled the holes, put the lower parts in correctly, and got some cheap upper from gb. The trigger was really spongy and at times almost needed to white knuckle the trigger to get it to fire. So I got a oem glock gen 3 trigger, tried it without the side on and is...
The problem problem and the fix is not specific to the G20. It's a problem that could exist in all Glocks.
Skip to The Diagnosis and The Solution at the bottom if you don't care about the process I went through to fix the problem.
I know there are already a lot of posts about this...
I'm trying to complete my compact Polymer 80 build and realized I need a trigger bar, with or without shoe is fine.
I could buy a new one for around 10 bucks delivered but I was hoping someone might have one in a parts drawer for nothing or nearly nothing.
I already had an...
Just like a gen 4 gun. I got this used on a trade and was told it was an sf model....it's not and I didn't notice at the time of the trade.
Trigger face is also smooth and not serrated I just noticed as well.
So did this guy swap the bar and housing or is this normal for a 20?
Glock triggers.com "The EDGE" competition trigger system. As new. Installed in my Gen 4 Glock 17 MOS but never fired a round through it and have sold the gun. Switched to the M&P. I'll sell it for $100 shipped. Payment via postal money order or PayPal plus 3%.
I'd be interested in opinions on the bump on the trigger bar used to mechanically center it under the firing-pin stop. My new Glock 26 Gen 4 clearly has this prominent bump. This YouTube argues that while this works to keeps it centered, it's at the expense of friction and significantly...
Very low count. Honestly under 200 rounds shot with it. Not what I was expecting so I just bought a ghost connector instead.
I had it installed on my GEN 3 G19.
Black on Black trigger with Zev trigger bar COMPLETE
2 striker springs honestly I think i might have mixed them up on packaging...