Glock Forum - GlockTalk banner
issue
1-6 of 6 Results
  1. General Firearms Forum
    I had a front locking block issue with my p80 when I built it. I could not get the slide on at all because of the issue. I got the new front locking block in the mail yesterday and it fit in with no problems. Right as I mated the frame with the slide and tried to pull the slide back, it started...
  2. General Firearms Forum
    Hey guys new to the forum here. Bare with me as this is my first P80 build and I understand it isn’t a Glock. Anyways, I just recently tly purchased a PF940C Frame W/ Jig and I have just received it in the mail. After opening the package and looking at the frame, I noticed something odd that I...
  3. Gunsmithing
    Hi, I just completed my P80 subcompact build. It was not my 1st attempt at an 80%. I’ve done some AR lowers & a P80 full size. The subcomact was extremely challenging. Not because it’s subcompact, but because the holes didn’t line up. I had to drill the holes in the rear rails out 1/32...
  4. General Glocking
    I want to start this question off by saying I apologize if this is not the correct thread for this question or if it has already been addressed. If either of those are the case, I would appreciate someone to point me in the right direction. Again, new to this forum so I hope I'm winging this...
  5. General Firearms Forum
    So, this happened about a month ago, and I wanted to wait until after speaking with the manufacturer before I posted a story about https://www.midwayusa.com/product/388966/hornady-critical-defense-ammunition-9mm-luger-115-grain-flex-tip-expanding-box-of-25 . Well, I received zero response, so...
  6. General Glocking
    Hey guys, I was wondering if anyone else has experienced this issue with their 43. I read about the magazine stick issue that was reported when the 43 was first released. My 43, in the right hand orientation for the mag release, does not have this issue. However, I am a lefty. Curious, I...
1-6 of 6 Results
Top