GlockTalk Forum banner

grip reduction

  1. General Glocking
    I'm a new GT member and this is my first post so please forgive me for any lapse of protocol. I generally carry a gen 3 26, primarily because the small size fits my hands, it is fairly easily concealable and it has essentially the same fire power (ability to accept larger capacity magazines) as...
  2. Gunsmithing
    After researching a lot of different grip hump reduction methods I stumbled on a new one in the presses of going down the applied heat path. Perhaps it’s not new, but I have not seen it anywhere. At any rate, I wanted to share the results so far. I started out by casting the magazine channel...
  3. Gunsmithing
    Hi, I have a Glock 34 GEN 3 and the grip SUCKS. I clearly felt it was too big, so after reading and watching other videos, I decided to do a grip reduction myself. In the first part, I just sawed the backstrap and filed it down to a size I felt was right. View...
  4. General Glocking
    I just did a minor grip reduction on my Gen 3 G26. This consisted of removing the finger grooves and filing down the checking where the fingers rest and the checking on the lower part of the backstrap. I made sure to remove only the raised areas and to not take off any more material than...
  5. General Glocking
    Hey all, I just received my Glock 21 back with a grip reduction, trigger guard undercut, and stipple job done to it and wanted to get some feedback on how it compares to other "custom" jobs you all have seen or purchased. I've seen some truly horrible looking jobs before, even from custom...
Top