GlockTalk Forum banner

extractor

  1. 1911 Forums
    I have two kimbers, one pro (4” bull) and one government (5”). The pro is much older. Its a I versus the newer 5 inch is a stainless II. Both in 45. the extractor in the pro finally gave out so I replaced it. I purchased a wilson series 70, installed, went to the range for a tune. Before the...
  2. Black Rifle Forum
    Hey guys, I have a 7.62x39 failzero BCG and the extractor claw sheared off about 2500rds into it. Just thought I'd share my experience and see what you guys think caused the issue. I believe the o-ring insert created too much tension on the claw and caused premature failure. Rifle is 16" carbine...
  3. General Glocking
    First time I ever have one of my glocks (Gen4: 2 G20's and 2 G40's) hiccup on me. And I consider this a major hiccup had it happened when I was hiking in bear country or facing any other threat. Although I would not be using the cheap rounds then either. I was at the range today, onto my second...
  4. Gunsmithing
    Hey guys, I’ve got a Gen4 G19. My issue with it is that if I pull the extractor back with my finger, it clicks and locks back. The only way to fix this problem and to release the extractor is to press down on the safety plunger. Then it just clicks back into place. I’ve read up on the same types...
  5. General Glocking
    Has anyone else seen weak extraction/ejector problems with the brass coming back at the face when shooting the new Gen 5's chambered 9mm? Common corrections?
  6. General Glocking
    I have subjected a gen 3 G19 to a fair amount of normal range use over the years, and have never had an extractor fail, but I'm also aware of the possibility that "new" and "innovative" production changes Glock has introduced over the years may be motivated as much by cost-cutting as anything...
  7. General Glocking
    I decided that I was going to do something about the Brass-To-Face (BTF) issue with my Glocks and set about learning all I can from here, other gun fora and YouTube. Then I'd go to the range to see which of my Glocks had an ejection problem and which didn't. Finally, I'd try, one at a time...
  8. Sold/Expired
    I have a new never used factory firing pin and extractor for sale. I bought these for a project but ended up not using them. I am asking $35 for the parts. Feel free to ask any questions or make an offer. The Extractor is new production with the LCI.
  9. General Glocking
    Just got a great little Glock 32C, Gen 3, but it has a non-Loaded Chamber Indicator (LCI) style extractor. What all parts are needed to convert over to the newer LCI style extractor?
  10. Sold/Expired
    Slide Package of parts ok! Extractor, channel liner, extractor plunger assembly & firing pin assembly, Pease Cheaper than Amazon, EBAY, etc. Text photos & price to 949-254-three l seven nine
Top