Glock Forum - GlockTalk banner
ejector
1-5 of 5 Results
  1. Gunsmithing
    I am looking for feedback on using my Glock 19 & 23 componets in different configurations. I have the following: 1. Glock 19 Gen 2 with grip reduced to G26 size with an RMR 2. Glock 23 Gen 2 3. 40 to 9 conversion barrel for range use in my G23 4. 9mm trigger housing What results might I expect...
  2. General Glocking
    I am looking for feedback on using my Glock 19 & 23 componets in different configurations. I have the following: 1. Glock 19 Gen 2 with grip reduced to G26 size with an RMR 2. Glock 23 Gen 2 3. 40 to 9 conversion barrel for range use in my G23 4. 9mm trigger housing What results might I...
  3. Gun-Parts & Access.
    Curious about lubrication on ejector. It seems that this part has friction and would benefit from light lubrication??
  4. Gunsmithing
    Was in IDPA match and my Glock kept FTE. Replaced Slide spring ejector assembly and spring, firing pin spring, and firing pin safety and spring and same issue. Had ordered a new loaded chamber indicator ejector from Lone Wolf, but failed to replace as it just didn't look right. At the range I...
  5. Gunsmithing
    Just want to see if anyone has had this happen in any of their Glocks. I picked up a new 34MOS Gen4. Pyramid Ultimate Trigger system, Suarez barrel, SS RSA, with a Vortex Razor mounted on it and Dawson co-witness sights. This is my 14th Glock, and I have done similar mods on all of them and no...
1-5 of 5 Results
Top