Glock Talk banner

Normal wear in inside frame?

Glock 43 
Tags
glock 43
4K views 18 replies 14 participants last post by  9x45 
#1 ·
Im new to the forum and this is my first Glock. Is this normal wear; I hate seeing blemishes on a new pistol. There was already knicks and dings in the barrel which were covered in be finish. What’s your thoughts!?

 
See less See more
1
#5 ·
My 43 looks exactly like that. Shape and everything. It's normal and not a problem at all. Now as for the barrel, a couple of thousand rounds later and there's hardly any noticeable wear to the finish. I understand about the nicks and dings. I'm the same way about my old guns too.
 
#6 · (Edited)
No, that is not normal, it is a manufacturing defect. The part has been molded incorrectly, the die looks off center. This is what we call a Friday afternoon gun. Time to call Glock and voice your opinion and tell them to fix it. If enough people did that they would make the gun right the first time.
 
#10 ·
Glock will tell you what others have said here...'keep shooting the pistol without concern about a cosmetic blemish'. However, send the photo to Customer Service to get an official response. They need to know when guns get distributed with cosmetic defects; Glock doesn't want folks like us talking about quality issues, even the ones that don't affect performance.
 
#11 · (Edited)
The little ding Nate is seeing is user caused by careless reassembly and not a factory defect nor cause for concern.

Nate,please field strip your pistol and while reassembling it pay attention to the interaction between the slide cover plate and the trigger housing,you will see that any slight misalignment will cause the two to hit and create the dent that you are seeing.
The ejector /trigger housing can also hit the slide cover plate on its rear face dinging it which is also a non issue.

When reassembling after a field strip you need to keep the slide of your G43 aligned with the grip frame until it is over the rear frame rails in order to prevent these minor blemishes.
 
#14 ·
The little ding Nate is seeing is user caused by careless reassembly and not a factory defect nor cause for concern.

Nate,please field strip your pistol and while reassembling it pay attention to the interaction between the slide cover plate and the trigger housing,you will see that any slight misalignment will cause the two to hit and create the dent that you are seeing.
The ejector /trigger housing can also hit the slide cover plate on its rear face dinging it which is also a non issue.

You need to keep the slide of your G43 aligned until it is over the rear frame rails in order to prevent these minor blemishes.
After looking at the photo more closely, your explanation may have merit. The spot in question looks like a piece has been chipped off rather than a mold imperfection. Damage from mishandling could happen anywhere in the chain, so who knows where it happened.
Wire Electrical wiring Cable Wood Technology
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top