Separate names with a comma.
I use the Sinclair Die, A small arbor press and a borrowed Harrel Powder Measure. Only for load development. Super easy.
Zombie and I still hang out and drink Whiskey. I have been shooting more rifle than anything. Had a baby girl so I don't cast in the house....
This is a lot to read. But I will say my 650 is way more trouble free then the 550 I had. 550 is going to poop dirt on the primer setup no...
Its about the MATH. The math on the FCD in .40 means the die sizes the case and bullet less then the math associated with using the same die in...
FCD is particularly a bad idea on the 10mm. The case is thicker so it will actually swage down the 10mm bullet. In .40SW this is less likely...
I just use a Lee Sizing die and don't make my life more difficult then it needs to be.
That's defined by the end user not me. People can come up with that on their own. And it can change as that user has more or less free time.
You guys arguing about Dillon over LCT are missing the point. I don't think most people who use the LCT are loading huge amounts of ammo with it....
I made it from a 550 handle that I bent using a jack and drilled and tapped for the roller.
The unescapable benefit is and always will be cost on a Classic Turret. You can get into the complete Classic Turret for about half the cost of...
I guess I am just tougher. ;)
The LCT is fine even for me when I am only loading about 50-100 rds every once in a while. If I know I am shooting a caliber even a moderate...
Frankly. It doesn't matter. They all make good bullets. Start with a FMJ or JHP (again, it doesn't matter). I would use 200gr for my first...
[IMG]
If it's a large bar you have to pull the bellcrank out so you can slide it out.