who's converted a .45 korean mag to 10mm

Discussion in 'The 10 Ring' started by Ethereal Killer, Feb 29, 2012.

  1. you know, I did that too when I attempted the mod, but now I'm wondering if I beveled far enough. I basically just knocked off the sharp edges left and right and did a solid bevel front and back.

    looking back at the followers and bodies I modded I noticed that one follower had not been beveled side to side only front and back.

    Maybe I need to go farther on the side bevels.

    I'm still stumped how you are getting that spring to fit without dragging in the 10mm body. Is it possible to measure yours?

    Wanna kill these ads? We can help!
  2. samurairabbi

    samurairabbi Dungeon Schmuck

    I will try to find my calipers and fulfill your request. Perhaps I just got lucky on the tolerances with my particular setup. But then, I'd rather be lucky than smart!

    I did more than just knock off the side "ridges" created by the narrower 10mm width; I bevelled th ENTIRE width of that created ridge. This may match what you mean by a "solid" bevel.

    I did not need to do any work on the follower to achieve my own personal "milspec" rating on my setup, so I did not even try.

    #22 samurairabbi, Mar 7, 2012
    Last edited: Mar 7, 2012
  3. It sounds like your solution would have solved what i was getting. the follower was hanging up at the transition.
  4. squeeze the sides in so the don't get hung up on the sides.
    notjustanothermini said 3 hammer strikes to the side. I just used a pair of channel locks with a rag wrapped around the mag a gave them a good squeezed. They work great for the range but would never use them where I would really depend on them.
  5. Tried the hammer thing today on one and oddly enough as imprecise as it sounds three mild mallet strikes did the trick almost perfectly. will test at range when I get a chance.

Similar Threads Forum Date
Who's converted to spinning to baitcasting? Hunting, Fishing & Camping Mar 23, 2010
Fender Bender With the Neighbor: Who's Fault? The Okie Corral Friday at 12:17 PM
Hallsville,MO Who's Going ? GSSF Aug 21, 2015
Who's your favorite bodybuilder? Strength & Conditioning Aug 7, 2015
So who's seen a Glock Kaboom? General Glocking Jul 30, 2015

Share This Page

Duty Gear at CopsPlus