close

Privacy guaranteed - Your email is not shared with anyone.

Welcome to Glock Talk

Why should YOU join our Glock forum?

  • Converse with other Glock Enthusiasts
  • Learn about the latest hunting products
  • Becoming a member is FREE and EASY

If you consider yourself a beginner or an avid shooter, the Glock Talk community is your place to discuss self defense, concealed carry, reloading, target shooting, and all things Glock.

tuning brass ejection

Discussion in 'The 10 Ring' started by Maine1, Nov 13, 2011.

  1. Maine1

    Maine1

    1,338
    16
    Jul 20, 2007
    Maine
    This is me getting pretty picky, but...

    I run my G-20 with a captured 22# sping and LW barrel. I'd liem to be able to find all/most of my brass. This combo will fling brass i don't know how far.
    On FALs and other weapons its possible to tune the ejection to help the weapon eject wiht less damge to the brass.

    Anyone tried this with the g-20? the ejector is a stamped part, and i was thinking that a slight change in the angle might let the bass come out at a lower angle, resulting in better recovery.
     
  2. _The_Shadow

    _The_Shadow Ret. Fireman

    4,520
    21
    Jul 23, 2007
    Southeast, LoUiSiAna
    Best I think you can do is shorten the ejector by 0.010" as not to kick it quite as hard, I have read where some have taken 0.020" off of the 1911 types.

    Anywat the ejector is an easy pert to replace if issues arise! Good luck!
     


  3. i have been contemplating the same thing. It sure is a pain to try to find at the range. still i have been using one of those hand held brass catchers. it seems to catch all the brass and if one or two fall out then they are by my side. Now it would be a different story if i were shooting dynamically then the brass would most likely be lost for ever.

    Anyway keep us posted.
     
  4. Maine1

    Maine1

    1,338
    16
    Jul 20, 2007
    Maine
    I'll give it a try, and see how it goes. i'd like to have at least a predictable pattern to use while tracking down brass. with my 200 gr loads the brass is hard to find.