close

Privacy guaranteed - Your email is not shared with anyone.

Welcome to Glock Talk

Why should YOU join our Glock forum?

  • Converse with other Glock Enthusiasts
  • Learn about the latest hunting products
  • Becoming a member is FREE and EASY

If you consider yourself a beginner or an avid shooter, the Glock Talk community is your place to discuss self defense, concealed carry, reloading, target shooting, and all things Glock.

Trouble removing trigger guard

Discussion in 'Black Rifle Forum' started by glock30user, May 26, 2011.

  1. glock30user

    glock30user

    341
    3
    May 31, 2007
    U.S.A
    I have a Stag 2TL and am trying to replace the trigger guard. My issue is I can’t get the old one out. I have tried to hammer out the roll pin on the back of the trigger guard but have just managed to ding it up…any suggestions?
     
  2. faawrenchbndr

    faawrenchbndr DirtyThirty fan CLM

    36,125
    483
    Nov 24, 2005
    Troy
    Hold on slick! :wow:

    Have you gotten the forward side to pivot down?

    Be dang azz careful or you will break off the rear tabs from the receiver.
    They are easy to remove, use a 1/8" drift, support the receiver and the
    tab and drive the pin out.
     

    Last edited: May 26, 2011

  3. glock30user

    glock30user

    341
    3
    May 31, 2007
    U.S.A
    yes i got the forward end out no problem…i didnt support the receiver when i was trying to get the pin out…maybe that was causing the force to be displaced. idk
     
  4. scottMO

    scottMO Moderator Millennium Member

    1,083
    10
    Dec 21, 1998
    LR Arkansas
    soak it for a few minutes in some sort of gun oil or wd40 as it should loosen up the roll pin...