close

Privacy guaranteed - Your email is not shared with anyone.

Welcome to Glock Talk

Why should YOU join our Glock forum?

  • Converse with other Glock Enthusiasts
  • Learn about the latest hunting products
  • Becoming a member is FREE and EASY

If you consider yourself a beginner or an avid shooter, the Glock Talk community is your place to discuss self defense, concealed carry, reloading, target shooting, and all things Glock.

SW 10mm factory barrels fully supported ?

Discussion in 'The 10 Ring' started by preventec47, Jan 18, 2012.

  1. preventec47

    preventec47

    265
    5
    May 2, 2010
    Atlanta, GA
    I wasnt sure about whether the SW 10xx series barrels were fully supported
    for hi power loads. Since I dont think anyone makes replacement barrels
    as for Glocks, I would not want one if they could not handle the higher
    power loads without worrying about smiles on the cases etc.
    Thanks
     

  2. _The_Shadow

    _The_Shadow Ret. Fireman

    4,519
    21
    Jul 23, 2007
    Southeast, LoUiSiAna
    S&W 10xx series are very strong guns and barrels, mine has handles everything I have ever put thru it!

    Bar-Sto use to produce the aftermarket barrels, but have since discontinued them.

    There is a retired Areospace engineer machinist (Bad Man 1) over at S&Wforum who has taken on the task of producing barrels for these fine weapons. He has had limited time on the CNC machines at the company he was dealing with to be able to finish them. He is very confident he will be able to complete them all 100 pieces. Most all are spoken for 40S&W, and 357Sig and yes 9x25Dillon in the 4.25" and 5.00" pistols.

    I have 4 on order and may get a 5th if it be comes avaliable. So I am being vey patient and communicating regulary with him on the project.