Privacy guaranteed - Your email is not shared with anyone.

Welcome to Glock Forum at

Why should YOU join our forums?

  • Reason #1
  • Reason #2
  • Reason #3

Site Description

Stuck 223 case in die tip

Discussion in 'Reloading' started by sig2009, Oct 26, 2010.

  1. sig2009


    May 3, 2005
    I have had a couple stuck cases in my sizer die when sizing. I have the RCBS Stuck Case Remover. Rather than putting the die in a vise risking messing up the threads I put the die upside down in my Dillon toolhead and lock it down with the RBCS Die rings that have the allen screw in them. Tighten that down and now I can drill out and thread the primer pocket without the die moving.
  2. shotgunred

    shotgunred local trouble maker

    Mar 1, 2008
    Washington (the state)
    I grab mine with a wood clamp. One of those you squeeze to tighten. then put the clamp in the vice. then drill and tap.

    I don't have an actual Stuck Case Remover kit. I just use 1/4 tap and a bolt out of my bolt bin. The tap cost $3.00 at ace.
    Last edited: Oct 26, 2010