close

Privacy guaranteed - Your email is not shared with anyone.

slide lever release spring broke below flush

Discussion in 'General Glocking' started by Magnum4, Dec 11, 2010.

  1. Magnum4

    Magnum4 Guest

    Glock 33 slide lever release spring broke below flush. Any tricks to remove remaining piece of spring?

    thanks
    Bruce
     
  2. JR

    JR Moderator Millennium Member

    Joined:
    Dec 29, 1998
    Messages:
    3,054
    Likes Received:
    1
    Location:
    Oldtown Idaho USA
    I assume you are talking about the slide lock spring (take down lever spring)?

    Good question. I have never seen or heard of this?

    Initially I would try tapping the frame upside down. I assume you did this until you were blue in the face? If the broken piece is accessible from the top you should be able to use a heavy needle to poke the side of the spring & pry upward. If this fails you may want to contact Fred at Glock Inc for another option?