close

Privacy guaranteed - Your email is not shared with anyone.

Possible PM9 Problem

Discussion in 'Kahr Club' started by glockman23, Jan 3, 2010.


  1. glockman23

    glockman23
    Expand Collapse

    Joined:
    Feb 21, 2008
    344
    0
    Location:
    Southwest Michigan
    So, here's the story. I went out to the range last week and put about 25 rounds through my PM9. I noticed it was shooting low and to the left. I though that odd, but I'd try it again next week and see how we did. I put 75 rounds through it today and it shot like a dream. I mean I was a surgeon with that baby at 25 yards. Now, I took it apart to clean the barrel and I'm noticing a lot of wear on the handle grip portion of the slide rails, right above the hole where you put the pin for the slide release. It looks like I wore 2/3rds of the damn thing right off! Could someone take theirs apart and take a look? Am I just being a hypochondriac? Could it have been shooting low and left because it wasn't properly seated on the rail? Does any of this make any sense?:dunno:
     

    Wanna kill these ads? We can help!
  2. Linux3

    Linux3
    Expand Collapse

    Joined:
    Dec 31, 2008
    1,399
    0
    Everybody has good and bad days shooting. Well, maybe not Jerry Miculek.
    If you were shooting low and to the left the most likely reason is poor trigger control caused by anticipation. Easy to do with a PM9.
    As for the rails above the slide stop. Those aint rails they are just a guide to aid in reinstalling the slide. There is only about 1/3 of the distance on my PM9, with about 2500 rounds through it, too. It's made that way.
     

  3. cziv

    cziv
    Expand Collapse

    Joined:
    Mar 14, 2009
    402
    0
    Location:
    OH
    Not exactly clear on which rails you're talking about?

    That said, when dis-assembled and holding the "lower" (polymer) half in your hand, in the shooting position, look down.

    The only rails to be concerned about being intact are the shiny metal strips in front and back, where the slide rides back and forth. :)
     
  4. glockman23

    glockman23
    Expand Collapse

    Joined:
    Feb 21, 2008
    344
    0
    Location:
    Southwest Michigan
    Thanks fellers:embarassed:. I was just being paranoid I guess. I just love my PM9 so much:crying:.
     
  5. chris in va

    chris in va
    Expand Collapse

    Joined:
    Jan 25, 2005
    3,887
    0
    Location:
    Louisville KY
    Pictures please.
     
  6. ltxi

    ltxi
    Expand Collapse

    Joined:
    Jun 20, 2009
    271
    0
    Location:
    Parker, Colorado
    Agree that low to the left is just pulling the shot....classic operator error, not the gun's fault.
     
    #6 ltxi, Jan 3, 2010
    Last edited: Jan 3, 2010