close

Privacy guaranteed - Your email is not shared with anyone.

Night sights on PCR

Discussion in 'CZ Club' started by jack76590, Apr 20, 2011.


  1. jack76590

    jack76590
    Expand Collapse

    Joined:
    Aug 15, 2004
    1,377
    1
    Has anyone installed night sights on their PCR? I am considering two do it yourself options.

    1. just putting on trijicon front sight from CZ custom or

    2. put on set of meprolights.

    I plan on doing myself. If I did first option don't have to remove rear sight. I think I can install front sight ok, but not sure how hard to remove and install new rear sight. Will the old tap, tap method work.

    If anyone has experience I would appreciate hearing from you. thanks.
     
  2. ace73

    ace73
    Expand Collapse

    Joined:
    Nov 7, 2006
    106
    3
    Location:
    S.E. MICHIGAN
    I put the front sight on my P01.....it was pretty easy! Tap out the pin and remove the
    old sight......you'll notice that the bottom of the old sight has a cut out where the pin
    goes thru. use a drill bit that will fit the hole in the slide......install new sight and slowly
    drill the cutout in the new sight. drill from the left side of the slide....the right hand cut
    of the drill bit will hold the sight in tight.
    The CZ Custom shop should have the sight, new pin and drill bit!!
    Hope that helps!
    p.s. visit the http://www.czforumsite.info/index.php?board=40.0
    for Trigger help!