close

Privacy guaranteed - Your email is not shared with anyone.

New to reloading....pistol primers

Discussion in 'Reloading' started by waldershrek, Jan 24, 2010.


  1. waldershrek

    waldershrek
    Expand Collapse

    Joined:
    Apr 23, 2008
    639
    0
    Location:
    The Empire State
    What is the difference between small and large pistol primers (nobody better say size)?


    I though pistol primers were all the same size but I guess not. What calibers would fall into each category?
     
  2. RLDS45S

    RLDS45S
    Expand Collapse

    Joined:
    Jun 8, 2003
    1,229
    0
    Location:
    MN
    Invest in a quality reloading manual! There are size differences. If you do not want to read the truth....but is the truth just like small and rifle primers are the same diameter, too. But, the LG rifle primer cup is taller.
     

  3. OLEDAVE

    OLEDAVE
    Expand Collapse
    What you said?

    Joined:
    Dec 25, 2009
    71
    0
    Location:
    Alabama
    http://ultimatereloader.com/?page_id=161

    Pistol Primers

    “It all starts with the primer…”

    Primers are small metal cups filled with high explosive compound. The primer is stuck by the hammer or firing pin, and when struck it ignites. When the primer ignites, it shootes a high intensity flame through the flash hole (hole between primer pocket and case interior) which ignites the powder charge. Primers are typically sold in packs of 100, or bricks of 1000 (10 packs of 100).
    Pistol primers side by side: 44 magnum (large pistol primer) and 357 magnum (small pistol primer)
    [​IMG]
    Pistol primer parameters

    There are a few basic parameters that you need to evaluate when buying primers:

    1. Primer size (large, small)
      Some cartridges require a large pistol primer (45acp, 44 special, 44 magnum, …) while others require a small pistol primer (9mm, 38 special, 357 magnum, …). Depending on what cartridge you are reloading, you need to buy the proper size primer for that application.
    2. Primer type (Regular, Magnum, Multi-Purpose)
      The type of primer indicates the overall intensity of the primer flame. Non-magnum loads (such as 38 special) only require a small flame to properly ignite the powder charge. Magnum loads require more activation energy since there is a lot more powder to burn. In some cases, a primer can be formulated to work with both regular and magnum loads (See WLP below).
    3. Hardness
      The hardness of the primer refers to the amount of force required to ignite the primer. Some primers are softer (Federal), some are harder (CCI typically), and some fall inbetween (Winchester). If your handgun has a lightened or modified trigger/action, you may need to use softer primers.
     
    #3 OLEDAVE, Jan 24, 2010
    Last edited: Jan 24, 2010
  4. waldershrek

    waldershrek
    Expand Collapse

    Joined:
    Apr 23, 2008
    639
    0
    Location:
    The Empire State
    So it looks like I need small primers for 9mm and .40......thanks guys
     
  5. WiskyT

    WiskyT
    Expand Collapse
    Malcontent

    Joined:
    Jun 12, 2002
    11,682
    1
    Location:
    North Carolina
    Right, just like it will tell you in a reloading manual. The load data includes primer type and is usually found after all the other stuff they want you to read. You know, the stuff that will prevent you from blowing up your gun and blaming everyone else.