Well, I have had a G23 for over 4 years and love it. Decided to pick up a new G26 Gen3 last week with a Oct 2012 fire date. Went to the range with it for the first time this afternoon, and so far have not been impressed. Prior to going to the range, I pulled the slide off, gave the barrel a good cleaning added just a little oil in all the normal spots. Loaded up with Blazer Brass 115 gr. First 5 rounds were flawless and ejected off to the right with no issue. Most of the last 5 rounds jammed. Most were FTF and the bullet was always stuck on the lower left corner of the barrel. I could usually rack again and the round would go in. Sometimes it wouldn't and I would have to eject the mag, and let the round fall out. Tried using both mag's over 80 rounds and had the same experience each time. First 5 rounds went fine, last 5 would have issues. Unfortunately I didn't have any other ammo to try. Also, usually the last round would load ok but the slide never locked back after the last round was ejected. I could pull the slide back again with the empty mag and it would lock back. Any ideas? It has the 336 ejector. I tried to snap a few pic's with my cell phone to show what it looked like. I appreciate any help you can provide. Thanks. Wanna kill these ads? We can help!