close

Privacy guaranteed - Your email is not shared with anyone.

Need some expert advice!!

Discussion in 'The Snubbie Club' started by rick45acp, May 6, 2010.


  1. rick45acp

    rick45acp
    Expand Collapse

    Joined:
    Jan 28, 2008
    2
    0
    I am awaiting the arrival of a new to me S&W 442. This is 442-1 in satin nickel. It left the factory in October 1995. It does not have the pin by the firing pin and it has the newer, larger yoke screw. Everything I have read says "if it is a 442-1 you can shoot +P's in it". A 25 year employee of S&W in customer service says "it left the factory in October 1995 and not 1996 so you should not shoot +P's in it". Does anybody know for absolutely certain, without doubt one way or the other? Thanks
     
    #1 rick45acp, May 6, 2010
    Last edited: May 6, 2010
  2. Dogguy

    Dogguy
    Expand Collapse

    Joined:
    Aug 2, 2008
    760
    0
    Location:
    Soggy South.
    If S&W says no +P, I would go with it.

    Couple of options I like: Federal 125 gr Nyclad HP and Fiocchi 125 gr JHP. Both are standard .38 Special loads and both seem to shoot well in my Airweights.
     

  3. the perfesser

    the perfesser
    Expand Collapse

    Joined:
    Jun 24, 2007
    368
    0
    You might want to try the Hornady Critical Defense standard pressure. (It also comes in a +P variety.) I have not tested it much yet, but manageable recoil and good accuracy thus far.
     
  4. Glock 17L

    Glock 17L
    Expand Collapse
    *GLOCKAHOLIC*

    Joined:
    Jan 19, 2004
    2,761
    1
    Location:
    Louisville Kentucky
    Your 442-1 should be up to the +P but I've seen this before were the factory didn't offer them +P rated until a bit later, I think they radiused the cylinder opening on the later ones..
    I use the Federal Nyclads 125gr HPs in my 642 No Dash & it's a great round with little flash & recoil & very accurate.. This same snub I've fit a 940-1 cylinder too & use the 125gr Nyclads in 9mm threw it for carry as well..
     
Loading...
Similar Threads Forum Date
I need some expert opinion General Glocking Apr 14, 2015
need some advice. General Firearms Forum Jun 3, 2014
Need some holster advice 1911 Forums Apr 30, 2013
Need some advice guys !!! General Firearms Forum Jun 5, 2012
CED - need some advice Reloading Dec 26, 2011