Help please

Discussion in 'General Glocking' started by jcookrowe, Oct 13, 2012.


  1. Okay guys need some help here I was just taking my 23 apart for cleaning and I scooted the slide too far back to take down but the take down pins were still engaged when I dry fired to reset the slide came off and hit the ground so I reassembled and repeated the process but check the takedown pins unfortunately I still slid the slide to far and when I dry fires to reset it the guide spring rod came out the front ....so I took it down everything looks normal and seems to function ok did I screw up? Should I take it back to the store? ...I'm scared 😪


    Outdoor Hub mobile, the outdoor information engine






    Outdoor Hub mobile, the outdoor information engine
     
  2. Loading...

    Similar Threads Forum Date
    Need to find an avatar ..... help please The Okie Corral Jul 13, 2015
    Please help my friend and vote! The Okie Corral Jul 1, 2015
    Help, Laptop recommendation please??? The Okie Corral Jun 19, 2015
    Mother's Mag overkill? Please help Gunsmithing Jun 13, 2015
    The Doors fans, help me out please. The Okie Corral May 5, 2015

  3. Butch

    Butch RetiredDinosaur
    Millennium Member CLM

    11,033
    18
    Sticks out like this?
    [​IMG]
     

  4. Butch

    Butch RetiredDinosaur
    Millennium Member CLM

    11,033
    18
    If so, you failed to reseat the rear end of the guide rod all the way down into the round 'assembly' notch on the barrel lug, and when you installed the slide, the rod snagged on a shoulder in the frame instead of going where it's supposed to go. Not likely that you hurt anything.
    [​IMG]
     
  5. Whew 😓 that's a load off thanks guys


    Outdoor Hub mobile, the outdoor information engine
     
  6. Check out these videos. Hope they help.

    [ame]http://youtu.be/DZf4mUM10Vc[/ame]


    [ame]http://youtu.be/7VTIqAMPOco[/ame]
     

Share This Page

Duty Gear at CopsPlus