close

Privacy guaranteed - Your email is not shared with anyone.

Welcome to Glock Talk

Why should YOU join our Glock forum?

  • Converse with other Glock Enthusiasts
  • Learn about the latest hunting products
  • Becoming a member is FREE and EASY

If you consider yourself a beginner or an avid shooter, the Glock Talk community is your place to discuss self defense, concealed carry, reloading, target shooting, and all things Glock.

Has anyone measured jacketed bullet diameters?

Discussion in '10mm Reloading Forum' started by TDC20, Jan 23, 2013.

  1. TDC20

    TDC20

    1,013
    285
    Apr 11, 2011
    The other day, I loaded up 50 Nosler 135 JHP's and then loaded 50 Sierra 135 JHP's. I noticed during crimping that the Nosler loads were rarely ever touching the Lee FCD sizing ring, while almost every Sierra round lightly brushed past it. Out of curiosity, I measured the diameters of the two unloaded bullets, and found that the Sierras were precisely .4000" with no measurable variation, while the Noslers measured between .3993" to .3998", with the average around .3995". I also had a box of Nosler 150's open nearby, so I checked a few of them, and they were about .0005 too small on average, also.

    I checked some Hornady 180 and 200 XTP's, and they were exactly .4000" and very consistent like the Sierras. I also had a few 180 GDHP's, and they measured very consistently at .4005". I had a box of PD 180FMJ's, they measured .4003" to .4005", most of them closer to .4005"

    So, has anyone else noticed this before? I couldn't find any history on the subject in a forum search. All this time, I thought that the 135 Noslers weren't very accurate because of loading them to hyper velocities. Now I'm wondering if the issue might be undersized bullet diameter.

    If anyone out there has time to measure some unloaded bullets from various manufacturers for diameter, I'd really like to hear your results. The fact that the Nosler 150's measure small also makes me wonder if this is a fluke lot of bullets, or if it's widespread on all Nosler .40/10mm bullets.

    It's a good idea to keep this in mind when changing bullets on a specific load. It could get you into some pressure trouble unless you back off a bit and work up again with the new bullet.
     
  2. ctious

    ctious

    554
    1
    Dec 12, 2011
    Yeah they are undersized. I stopped shooting the jacketed cause ofthat. Cast lead is way better.
     


  3. _The_Shadow

    _The_Shadow Ret. Fireman

    4,519
    21
    Jul 23, 2007
    Southeast, LoUiSiAna
    Yes, it happens...But the LEE FCD can also squeeze the bullet down some if the brass is thick or just in general. Check the before diameter and after if you pull some to check it. I found the FCD actually made some bullets loose with its use, so I use mine only as a "Pass-Thru" sizer now...

    Good luck!
     
  4. Taterhead

    Taterhead Counting Beans

    3,595
    107
    Dec 13, 2008
    Boise, Idaho
    I have observed Noslers to be just undersized too.
     
  5. TDC20

    TDC20

    1,013
    285
    Apr 11, 2011
    You make an excellent point, Shadow. I'm going to follow your lead on that, too.