close

Privacy guaranteed - Your email is not shared with anyone.

glock parts

Discussion in 'General Glocking' started by rickyp, Nov 4, 2012.

  1. rickyp

    rickyp

    38
    0
    Jun 1, 2012
    Maryland
    I am working on converting a glock 19 in to a gock 23
    I have a glock 23 barrel and slide, Last night I just changed the ejector.
    I am now tinking about doing some more work to it and wondering if the things I am looking at are a waste of money or work?

    1) Glockworx Titanium Firing Pin Safety
    2) Lone Wolf 3-1/2 lb Connector
    3) Glockworx Competition Trigger Spring

    I am also thinking maybe a titanium striker
     
  2. TxGlock9

    TxGlock9

    4,962
    20
    Nov 22, 2010
    BMT, TX
    Not sure if you can do this.. 23 to a 19 is fine but the other way around I don't think so.
     

  3. rickyp

    rickyp

    38
    0
    Jun 1, 2012
    Maryland
    Txglock9 it is very easy to do. The only diffrance between the 19 and 23 frame is the ejector and i just changed it out. The 19 ejector did work but it was a little close to the primer so for safety sake i changed them out. Only about $8 in parts and 5 minutes of work.
     
  4. TxGlock9

    TxGlock9

    4,962
    20
    Nov 22, 2010
    BMT, TX
    I was under the impression the breechface and the chamber don't line up, but if it works it works.. :)

    As far as if the mods you're curious about, I would go with the trigger spring and ghost 3.5 connector. I can't say anything about the titanium striker bc I never used it before.
     
  5. rickyp

    rickyp

    38
    0
    Jun 1, 2012
    Maryland
    I put a entire glock 23 factory (for now) slide on the frame so no issues.
     
  6. Arc Angel

    Arc Angel Deus Vult!

    6,920
    6
    Sep 20, 2003
    Penn's Woods
    That's true for a 9mm conversion barrel when it's installed in a G-23 slide. The difference in where the striker hits the primer ain't much, though.
     
  7. TxGlock9

    TxGlock9

    4,962
    20
    Nov 22, 2010
    BMT, TX
    My mistake in comprehending what you originally posted. doh!
     
  8. DannyR

    DannyR Moderator Millennium Member

    19,850
    208
    Dec 17, 1998
    Roanoke, Virginia
    As long as your G19 has a locking block pin, you are good to go.
     
  9. Arc Angel

    Arc Angel Deus Vult!

    6,920
    6
    Sep 20, 2003
    Penn's Woods
    Ain't THAT the truth! (Thanx, Danny. I forgot about that one; but, then again, it's been awhile since that design change.) ;)