close

Privacy guaranteed - Your email is not shared with anyone.

gen 4 problems

Discussion in 'General Glocking' started by jetmech, Apr 4, 2010.

Tags:
  1. jetmech

    jetmech

    Joined:
    Jan 26, 2010
    Messages:
    7
    Likes Received:
    0
    i cleaned my g22, when i put the slide back on i noticed that the recoil spring was sticking out the slide just a little more than normal, about enough to get your thumb nail under it, the slid on this gen 4 was never easy to get on and off ( compaired to say a gen 3) but it has never done this.it is also starting to show wear on the front side of it (slide side) also i keep loosing the plug for the end of the receiver.
    does anyone make gen 4 parts? is there a special plug for a gen 4?
     
  2. JR

    JR Moderator Millennium Member

    Joined:
    Dec 29, 1998
    Messages:
    3,054
    Likes Received:
    1
    Location:
    Oldtown Idaho USA
    The recoil spring is about the only thing that is different on a Gen4 pistol. Everything else is the same. Unfortunately I have not seen any offered in the aftermarket field (yet).
    If your plug is falling out try wrapping a piece of electricians tape around it then insert it back into the frame.