close

Privacy guaranteed - Your email is not shared with anyone.

g23 extractor spring assembly

Discussion in 'Gun-Parts & Access.' started by crushproof, Mar 22, 2010.


  1. crushproof

    crushproof
    Expand Collapse

    Joined:
    Oct 17, 2009
    262
    0
    tonight i just did a basic field strip cleaning on my 23, when i was looking at the cover plate and you know the little cutout on the cover plate on the upper right that shows the back of the extractor assembly it had a copper tint to it. got me worried was rust so i took off cover plate and removed the extractor assemble i took a little hoppes to it and took most of it off but not completely. so i used very gently a little sand paper over the back of it and got it all off. what i'm wondering folks is if using the sandpaper a little on the back of the ectractor assembly to get the stuff off would affect reliability? -thanks
     
  2. Glockrunner

    Glockrunner
    Expand Collapse
    HOOYA DEEPSEA

    Joined:
    Sep 10, 2001
    4,250
    2
    Location:
    SC
    It is good that you are learning to clean and inspect your firearm.
    Without being able to see the parts you are talking about I would have to say replace that part with a new one at your first opportunity.

    Any good GLOCK ARMOR in your area will be able to get the parts you need.

    In the furture, may I suggest a wirebrush and some oil instead of sandpaper?

    Good luck!
     

    #2 Glockrunner, Mar 22, 2010
    Last edited: Mar 22, 2010