close

Privacy guaranteed - Your email is not shared with anyone.

G22 15° extractor cut

Discussion in 'General Glocking' started by ls, Jan 24, 2013.


  1. ls

    ls
    Expand Collapse
    Millennium Member

    Joined:
    May 14, 1999
    254
    0
    Location:
    D/FW
    When did they start making the 15° extractor cuts on the G22s? I looked at the serial number project, but did not find anything on the G22s.
     

    Wanna kill these ads? We can help!
  2. SJ 40

    SJ 40
    Expand Collapse

    Joined:
    Jan 17, 2011
    13,192
    2,807
    Location:
    Vermont
    I don't know the exact time frame,the oldest G 22 I have was produced in 2002 and it has the 15 degree extractor cut on slide.
    I also have a 1999 two pin Gen 3 G 19 that is not so cut with a machined extractor.
    My guess is sometime between those two dates, Danny R or Butch would most likely know the exact date. SJ 40
     

  3. ls

    ls
    Expand Collapse
    Millennium Member

    Joined:
    May 14, 1999
    254
    0
    Location:
    D/FW
    I was not specific enough in my post. I meant to specify gen 2 G22s. IIRC, all the Gen 3s have the cut, but what about the gen 2s? Did they ever make any gen 2 G22s with the 15° extractor cut?
     
  4. Patchman

    Patchman
    Expand Collapse
    Florist

    Joined:
    Jul 29, 2008
    17,014
    2,260
    Location:
    Land of Flora, Fauna & Merriweather
    Funny because I also have a 1999 2-pin G-19 which does have a 15-degree cut. Also, the Glock Armorer's manual I got from 2000 already mentions the 15-degree cut. So I'm guessing the 15-degree cut began transitioning sometime during 1999. It would make sense if Glock used up whatever older (90-degree) slides first.

    But as to G22s, IDK. Didn't all .40 cal and 9mm Glocks share the same slide and frame (ie: 2-pins) at that time?
     
    #4 Patchman, Jan 25, 2013
    Last edited: Jan 25, 2013
  5. Patchman

    Patchman
    Expand Collapse
    Florist

    Joined:
    Jul 29, 2008
    17,014
    2,260
    Location:
    Land of Flora, Fauna & Merriweather
    Gen 2? IDK, but I doubt it. Gen 3 Glocks came into being in 1987(?) And it seems gen 3 guns until 1999 still had the 90-degree extractor cuts.
     
  6. GRT45

    GRT45
    Expand Collapse
    Transform & Win

    Joined:
    Jun 20, 2010
    3,084
    144
    Location:
    Texas
    Found this record in the Glock Serial Number Research Project database:

    BKD*** G-22 GEN 2.0 1995-05-01 Begin 15o Extractor cut this model

    The Armorer's Manual U.S. Addendum (Page 4) notes that the 15° Ejection Port Cut Change first appeared in December, 1994. If memory serves, from the Armorer Course I recall the Instructor said the 15° cut appeared first in the 45ACP/10mm pistols and the other models followed later.
     
    #6 GRT45, Jan 25, 2013
    Last edited: Jan 26, 2013