close

Privacy guaranteed - Your email is not shared with anyone.

Welcome to Glock Talk

Why should YOU join our Glock forum?

  • Converse with other Glock Enthusiasts
  • Learn about the latest hunting products
  • Becoming a member is FREE and EASY

If you consider yourself a beginner or an avid shooter, the Glock Talk community is your place to discuss self defense, concealed carry, reloading, target shooting, and all things Glock.

Ford Taurus says "door ajar"

Discussion in 'Car Forum' started by G30Big, Oct 13, 2007.

  1. G30Big

    G30Big

    26
    0
    Jul 29, 2007
    NE Florida
    My wife's 99 Taurus is telling us that a door is ajar and the indoor light stays on even though all are shut properly. This is driving us nuts!

    Any ideas oh how to troubleshoot and fix?

    thanks
     
  2. First, you have to figure out which door switch is not working. It's most likely the driver's door, since it is used the most. I'm not familiar with the exact way that Ford wires there system, but most are pretty much the same. This will be the easiest if the door switches are the push button type that make contact with the door when shut. If they are internal to the latch, then the door panels will have to come off of each door until you find the culprit. The switches are normally closed switches that ground the circuit when closed turning on the light and chime, when the doors are shut the switch opens, taking away the ground. You have a circuit that is staying grounded all the time.

    Start by opening one door and disconnecting the switch for that door. When the light and chime quit, that switch is staying closed all the time, put in a new one. Remember to reconnect and close the door before proceeding to the next one. If you have disconnected all the switches and the light stays on, then you have a short to ground on the power side of the switch. Grab a wiring diagram and figure out what controls the light and chime, most likely the body control module. Disconnect all the switches and the module, check continuity to ground with a multimeter on the module(control) side of each switch until you find the one shorted. Now, you can either string a new wire, or find the short and fix it. It's also possible that the module is shorted to ground internally, but not that likely.

    Of course, you can also just buy a new driver's switch, throw it in, and see if that fixes it before digging really deep into it. I would say the 9 times out of 10, it's the driver's door switch broken internally causing the short. Good luck.
     


  3. G30Big

    G30Big

    26
    0
    Jul 29, 2007
    NE Florida
    thanks so much for the help, I'll keep you posted on the results.
     
  4. FoxMustang

    FoxMustang We Deal in Lead

    313
    0
    Dec 15, 2001
    I had the same problem every now and again with my '98 Mark VIII. Blast the latch in the door with WD40. Apparently this is a pretty common problem with Fords of that era.
     
  5. G30Big

    G30Big

    26
    0
    Jul 29, 2007
    NE Florida
    I'll nail them in the morning with WD40. I checked into a manual at the auto parts store but it doesn't cover any of this stuff...

    thanks
     
  6. G30Big

    G30Big

    26
    0
    Jul 29, 2007
    NE Florida
    WD40 fixed the Taurus, now my daughters' 96 Mustang is dinging whenever the door is open, even if the key is out of the ignitiion and the lights are off. Any insights to share?

    thanks!
     
  7. txinvestigator

    txinvestigator

    1,318
    2
    Jun 8, 2007
    DFW
  8. Douglas in CT

    Douglas in CT Millennium Member

    [​IMG]
    So true....so true!

    PS:
    You beat me to it! [​IMG][​IMG]