Everybody talks about how great this kit is and how easy it's to install plus this and plus that but, I notice that there is not a single post showing how to take it apart or, lets say, "a complete disassembly" of the slide, not even a video on You Tube. I don't think it can be more difficult than a Glock slide but, it will be nice if AA put puts out a formal instruction sheet showing the few steps on how to remove the extractor in case it gets damage or plug with carbon. I noticed that the .22 Advantage Arms Conversion Slide uses a little fastener, not a solid pin, to hold the extractor in place. That fastener can be removed by pushing/pressing it out with a (-3/32) brass pin punch in order to remove the extractor and the safety plus both springs. Well, at least it worked for me. You'll be surprised how much carbon builds up inside these parts, specially if you run the kit wet so it's a good idea to clean it at least every 200 rounds. Advantage Arms sells extractor and safety kits but they won't tell you how to remove them maybe because they want us to mail the kit back to CA? or...... probably we need to take the AA Conversion Kit Armorer's Course..