Privacy guaranteed - Your email is not shared with anyone.

Welcome to Glock Forum at

Why should YOU join our forums?

  • Reason #1
  • Reason #2
  • Reason #3

Site Description

Finally found a Good Gunsmith in South FLA

Discussion in 'Gunsmithing' started by TedG, Nov 1, 2011.

  1. TedG

    TedG Infidel USA

    Some of you from the area might remember Brian from Revere Range. He had done some 1911 and Glock work for me in the past.... and then he sort of disappeared. I figured he had retired.

    Well, he only semi-retired and is still gun-smithing out of his house in Pompano. He has his equipment (lathes, presses, etc.). Brian knows his business and he is very reasonable. He just did a repair on an AR15 for me.

    Between Palm Beach and Miami, I was lucky to find him "OPEN FOR BUSINESS" again.

  2. Good to know.. thanks for the info!

  3. Is Revere still in business?
  4. TedG

    TedG Infidel USA

    I think Revere is still in business, though I haven't been there in a long time. The air is just a little too heavy for me. I go to Markham Park.

  5. The last time I was there the ceiling was falling in so the air might be little better now with the extra ventilation.

  6. :rofl: I wouldnt go there unless I was wearing a lead rated mask!
  7. So where is Brian located at ? Also is he the Brit gut that Revere had as a gunsmith back over 8 years ago?
  8. Honestly I haven't been back since the last time I was there and the guy behind the counter had a gunshot clean through his hand. Its been at least three years and maybe longer.