close

Privacy guaranteed - Your email is not shared with anyone.

do the pass thru dies de-cap?

Discussion in 'Reloading' started by mikecurnow, May 17, 2010.

  1. mikecurnow

    mikecurnow

    23
    0
    Apr 16, 2010
    should have said push thru in the title.

    I was wondering if the push thru dies also decap, and if not how do you make use of them in the common progressive press's (LNL, 550, ect)?

    Thanks
    <input id="gwProxy" type="hidden"><!--Session data--><input onclick="jsCall();" id="jsProxy" type="hidden"><input id="gwProxy" type="hidden"><!--Session data--><input onclick="jsCall();" id="jsProxy" type="hidden"><input id="gwProxy" type="hidden"><!--Session data--><input onclick="jsCall();" id="jsProxy" type="hidden">
     
    Last edited: May 17, 2010
  2. Colorado4Wheel

    Colorado4Wheel

    14,973
    180
    Nov 2, 2006
    CO
    They don't decap. They are also better suited to a single stage press. The push through section is designed like the shellholder on a Single Stage.
     

  3. dudel

    dudel

    6,338
    1,872
    Dec 10, 2008
    Texas Hill Country
    :supergrin: How could they? If there's a decapper pin, something is holding it in the die. How would you push the brass past that?

    You also don't use them in a progressive press because that would hold on to the brass. You're not using a standard shell holder with the push through dies. It's more similar to a boolit sizer.
     
    Last edited: May 17, 2010