Hey guys. Recently got my crossbreed supertuck, and I'm having printing issues. I'm not skinny but not huge either: 225lbs, 6', and some belly fat. I've tried almost every combination of the given holes for the clips and can't seem to find a good balance between concealment and draw ability. If I put the holster clips at it's highest setting (top holes) It makes it very difficult to draw, only two fingers on the low part of the grip. At this position, the gun prints very little. I've tried canting the holster also, which seemed to help the butt end of the grip not stick out and print, but at the highest setting canted, there's still printing. Am I asking for too much here? Never had an IWB holster before, so I don't have much to compare it too. Gun: Gen 3 g19, 4 oclock position Wanna kill these ads? We can help!