I have been reloading on my LCT for about a year now with a good number of rounds under my belt, not a single issue so far. Well tonight I was loading up a hundred rounds and 60 rounds or so into the session, I brought a casing up into the powder die and it felt a bit off, after it came out, I looked in the case as usual before placing a bullet, and...no powder. I took a look at the powder measure and the spring return had not returned the powder disk under the hopper after the previous round, thus not reloading the disk! I had the spring hesitate before, but never stick. I pulled the bullet from the previous round which caused the drop to stick and the charge weight was correct. This gave me a chance to tear the press down and clean all the dies, as well as the powder measure. The measure still hesitates sometimes when I tested it after the re-assembly. Anybody know what might be causing this, or should I just contact Lee?