close

Privacy guaranteed - Your email is not shared with anyone.

Carbon buildup around gas tube and gas block

Discussion in 'Black Rifle Forum' started by 88_gurgel, Dec 21, 2009.

  1. 88_gurgel

    88_gurgel

    Joined:
    Feb 25, 2007
    Messages:
    1,417
    Likes Received:
    0
    Location:
    Minnesota
    I am getting some blow by around the gas tube on my AR between the tube and the block. Is this a normal thing? It hasn't caused any operation problems at all. Is there a seal or is it a press fit?

    I am not too concerned with it but just wanted to know if it was normal.
     
  2. Mnukedude

    Mnukedude Lurking

    Joined:
    Dec 14, 2001
    Messages:
    2,648
    Likes Received:
    1
    Location:
    With my wife
    A little of this is probably normal. Is the rifle new? If so, it means the seal between the the gas tube and the gas block is not quite perfect. Since it isn't interfering with weapon operation, I wouldn't worry about it right now. There is a good possibility that over time, carbon buildup inside the gas block area the tube mates into will seal the leak anyway. If it does, it is still no threat to the normal operation of your weapon. The only time it will bite you at that point is the next time somebody has to yank that gas tube out (most likely in connection with a barrel replacement), but even then, it's the gunsmith who will be putting up with that, not you.