close

Privacy guaranteed - Your email is not shared with anyone.

Welcome to Glock Talk

Why should YOU join our Glock forum?

  • Converse with other Glock Enthusiasts
  • Learn about the latest hunting products
  • Becoming a member is FREE and EASY

If you consider yourself a beginner or an avid shooter, the Glock Talk community is your place to discuss self defense, concealed carry, reloading, target shooting, and all things Glock.

Agrip arghs!

Discussion in 'Gun-Parts & Access.' started by migm, Jan 8, 2010.

  1. migm

    migm

    339
    0
    Jan 4, 2010
    I've got a glock26 and I'm trying to put the agrip on it. The problem I'm running into is if I put it just under the slide release just under that little notch of the slide release then when I go to wrap it under the trigger on the right side the material is too low to fit flush against the bottom of the trigger guard. Any tips? I'm worried I'm gonna eff up this material and have to reorder.
    M
     
  2. kennjen

    kennjen

    301
    0
    Apr 7, 2009

  3. migm

    migm

    339
    0
    Jan 4, 2010
    Yeah I just came to the same conclusion. Now I have a little extra on the sides on the end of the grip that I'm trying to tuck and pinch into the magazine well. I have a feeling this is going to make it hard to load a new mag
     
  4. farley45

    farley45

    2,112
    0
    Feb 23, 2009
    Nebraska
    I messed up the first one I tried to put on.


    I bought a pair of small scissors and a crafting razor blade (one that looked like a pen but had a small razor blade on the end). I used those to cut excess off of areas where it didn't want to go before or overlaped too much. It made the process much easier.
     
  5. migm

    migm

    339
    0
    Jan 4, 2010
    Yeah I think I screwed it up. I assume the magazine is supposed to be able to fall freely from the well when the release button is activated? Not anymore.. I think it's because its not quite flush with the top of the frame since I was worried about the slide release. I'll probably take your suggestion and just trim the bottom pieces on the sides off unless there are any other suggestions or ideas?
     
  6. racer88

    racer88 NRA & SAF mbr

    2,610
    66
    Oct 14, 2009
    The instructions indicate the material is supposed to go under the slide release. I say no way. At least it would NOT fit under the slide release on my G27. So, I just cut the material around it.

    I had to do a little bit of trimming elsewhere around the edges.... especially at the magazine well opening.

    The only other issue I've had since is the material that extends in FRONT of the slide release kept peeling back as a result of holstering it in my Crossbreed Supertuck. So, I've cut that part off, too. I'll see if the rest stays put.

    All that said, I like the Agrip. I think it's perfect for IWB and EDC. I have Talon grips on my HD G23, which I also like. But, I think it would be scratchy if I was carrying IWB.
     
    Last edited: Jan 8, 2010
  7. migm

    migm

    339
    0
    Jan 4, 2010
    Agreed -- there's no way it would fit. I tried it and its just too thick and the release is just too flush against the frame
     
  8. migm

    migm

    339
    0
    Jan 4, 2010
    Ah crap.. another problem. I need to get into the trigger housing assembly pin but the agrip covers this up. Arghhh now what?