close

Privacy guaranteed - Your email is not shared with anyone.

Adding finger groves to Crimson Trace?

Discussion in 'Sights, Optics and Lasers' started by glock39, Feb 28, 2010.


  1. glock39

    glock39
    Expand Collapse

    Joined:
    May 26, 2005
    356
    9
    Location:
    Tyler, TX
    I have a Nightguard 325 (N-frame, 45ACP) that I would like to put Crimson Trace grips on. But Crimson Trace doesn't currently make a round butt grip for N-frames. Most N-frame grips are a little large for me, the factory Nightguard grips just barely fit my hand. Specifically, my little finger is apparently a bit shorter than average, and with most square N-frame grips my little finger can't quite reach far enough around to the front to contribute toward actually helping to hang onto the gun.

    I don't think that Crimson Trace has any circuitry in the bottom front of their revolver grips. Although I'm sure it would void the warranty, I'm wondering if it's possible to cut a finger grove in order to improve the fit for my little finger? Has anyone tried cutting finger groves in a laser-grip?
     
Loading...
Similar Threads Forum Date
Adding finger grooves to a Gen2 19 General Glocking Feb 25, 2015
Crimson Trace! The 10 Ring Apr 2, 2011
Thinking of adding Crimson Trace The Snubbie Club Aug 7, 2010
Crimson Trace 1911 Forums Jan 20, 2010
crimson trace Smart Shopper Jun 7, 2006
Duty Gear at CopsPlus