close

Privacy guaranteed - Your email is not shared with anyone.

Welcome to Glock Talk

Why should YOU join our Glock forum?

  • Converse with other Glock Enthusiasts
  • Learn about the latest hunting products
  • Becoming a member is FREE and EASY

If you consider yourself a beginner or an avid shooter, the Glock Talk community is your place to discuss self defense, concealed carry, reloading, target shooting, and all things Glock.

'98 integra won't start

Discussion in 'Car Forum' started by quichedem, Oct 13, 2005.

  1. quichedem

    quichedem

    272
    23
    Nov 12, 2004
    N.O. LA
    My '98 is not getting spark. Checked fuses, but no dice. Also just ordered an electrical troubleshooting manual for wiring diagrams and voltages. Plan to test that when is comes in. Just wondering if anyone else had this problem. Starter motor goes, but no spark. If it isn't the coil pack, might be wiring?
     
  2. Rob1035

    Rob1035 Skeet Surfer

    895
    0
    Jan 24, 2005
    Charlotte NC
    distributor perhaps? I had one go out of my 98 ITR, there's a screw that holds the rotor on that can come lose
     


  3. streeter69

    streeter69 This is Kewl

    450
    0
    Nov 25, 2001
    I like annoying people.
    Pull off the oil cap, have some one crank the the engine, is the camshaft moving??
    Next is pull the cap off, check and see if the rotor looks okay. These year hondas and acuras have a problem with the dist.. Lack of lube causes the the shaft to burn up the dist. Basically it burns up the ignitors:(
     
  4. Seen a lot of rotor set screws come loose, as Rob1035 mentioned. In fact, it's the first thing I check when I get in a Honda/Acura with a cranks won't start complaint.
     
  5. quichedem

    quichedem

    272
    23
    Nov 12, 2004
    N.O. LA
    Thanks for the replies. I am unable to access internet often, so I am just getting to read this. What you've posted seems to narrow it down to some real p.i.t.a. work. Anyone wanna buy an integra?
     
  6. Rob1035

    Rob1035 Skeet Surfer

    895
    0
    Jan 24, 2005
    Charlotte NC
    the distributor is not a difficult job from what I remember....