[MP9]

Hey guys..

I have a g19 gen4. When new, the trigger pull was like 6.5#. I installed the - connector and 6lbs trigger spring, now it is around 4.6 -5lbs...

the thing is I would be using it for some idpa matches, I would like to have a better trigger.. I thought it would be around 4#,

what else can I do to download the trigger pull?

I was thinking in getting the gen3 trigger bar without the bump...
and dont know if to get it serrated of as original. does it(serrated) has the bump?

[Krav Maglock]

Vanek Triggers are SWEET.....check them out,you can get all the way down to 2 lbs.

[vmann]

you can get the gen 3 trigger bar with or without the serrated trigger, look at the lonewolf site and it lists both....i personally would get the gen 3 trigger bar for sure, i dont like the feel of the 4th gen trigger with the bump on the bar.....

[MP9]

what model should I get?(for my g19 gen4)

I read the SP00357 is the gen3 trigger bar without bump. Is that correct? but I read too, glock has like 2 similar models, no sure it come with the bump or a new angle in the rear..

[Glock Junkie]

4 lb striker spring, reduced power plunger spring and polish the internals to smooth it out. What connector did you put in it?