[Jager1147]

Our Gen. 4 guide rods have really taken off! I have been absent on this forum for a while, so the first person who replies wanting a Glock Gen. 4 guide rod for G17, G19, G34 or G35 will receive one for FREE!

Our guide rods have been credited with helping many suffering from the Gen. 4 malfunctions that have been experienced by some.

Our guide rods are complete Gen. 4, not simply an "adapter" which uses a Gen. 3 rod. The Gen 3 rods do not sit in the frame properly, and the back of the smaller Gen. 3 guide rods swim in the larger Gen. 4 frame channels. The MAJOR beneft of using a steel guide rod is to promote consistent cycling, just as was the purpose in 1911's. Using a Gen. 3 rod in a Gen 4 frame will NOT propmote consistent cycling.

Thanks again fellow GT'ers, and first to respond is the winner.

jager

[amorican88]

Sure, I'll take one.

[Jager1147]

That was fast,

Amorican88 you're in.

Please go to my website and send me an e-mail from there with your shipping info. Be sure to specify which model, and Polymer or steel. Good luck, and please report back in this thread.

jager

[amorican88]

Must be my lucky day, thanks Jager!

[JBarbaresi]

Originally Posted by amorican88

Must be my lucky day, thanks Jager!

lucky you. jager guide rods are by far the best on the market, very smooth operation and excellent quality. i just placed an order for another gen3 model and a couple springs today.

here are some pics of the gen4 rod installed.

[amorican88]

Thank you so much Jager Products! My SS guide rod was in my mailbox today. Looks like an excellent quality item. Can't wait to shoot it. Thanks again...

[Jager1147]

You're welcome!

Can't wait to hear your shooting report.

[sellersm]

I'm looking for new rods/springs for G19 and a G32C. The G19 has a threaded LW barrel. Currently has a Sprinco setup in it which isn't working out so well.

The G32C has a glockmeister rod/spring (can't recall the weight).

I generally shoot mid-level loads in each one, just target shooting.

Recommendations? I'm happy with a few diff. spring weights to try out, depending on my loads. I push the G32C harder than the G19, it's just so much fun to shoot!!

[Jager1147]

For the G19, I'd recommend our captured steel guide rod with the 15# spring. This will allow the slide to cycle a little faster with the typical range ammo out there like WWB 115 gr. ammo.

For your G32C, I would try the 18# spring on the the captured steel guide rod. Picking the right recoil spring is very subjective, because what feels right to each shooter may be a little different - but I would start here. Thanks!

jager

[Keyhole]

Good stuff Jager. Please keep it up!

[sellersm]

Thanks jager! Order incoming...

[Jager1147]

I'll have Gen. 4 G20 and G21 rods ready in a few weeks!
Thanks, jager