[bilkay]

Speer Lawman. From the online sources already mentioned.

[tcruse]

S&B, MFS2000 (brass, Cabelas) - 1200+ fps, reloadable good quality
WWB - Walmart or other places - standard to compare against
CTD Ruag Precision Ammo - 1200+ fps, clean, zinc plated steel

For special treat try some Cabelas Herters TNJ (Total Nylon Jacket ). Made in usa by Blazer. Very clean and very low on lead exposure. If supply lasts and the price stays reasonable, this will probably become my only choice. Considered by most as not reloadable.

[Lindenwood]

It's a Glock. Run anything through it that is made of metal :P . Though I load my own at about $12 per 100 .

[rdpG19]

Blazer 115gr excellent clean and cheap, I buy 1000rds at a time and get it for about 9.50 p/box. Highly recommend it.

[plouffedaddy]

Silver Bear. The stuff is as clean as Blazer, Wincester, Speer, ect... and is way cheaper when you buy it in bulk. I run it in handguns, ARs, AKs, SKSs, and have never had an issue. They sell it on militaryshooters.com (I don't own it or anything, just trying to pass on a deal...)

[Dogpatch06]

I just ordered 1000 rounds of Speer Lawman from SGAmmo.com. Thanks for the link.

[mervstump]

Originally Posted by TexasGlockster

So before we started with this shindig, I'm not a huge fan of shooting crappy rounds through my G17. That being said, I'm looking for a decent, range round that is relatively inexpensive. Thoughts?

I used WWB until I discovered Aguila from Military Shooters as described below. Price is right and so is the shipping cost. My Glock 17 feels much better with this than it does with the WWB.

9mm Aguila 9mm 124gr FMJ (500 rds) ** IN STOCK **
Aguila 9mm 124gr FMJ (500 rds) ** IN STOCK **
$97.50 - 54 in stock
Mfg:A9AGFMJ
SKU:0
Merv

[Golddog]

Good suggestions - I've had success with most of the above. However, CCI aluminum-cased has NOT run reliably in any of the many pistols I've owned, including Glock 19's, a 26, and a 34.

[Glockman67]

Originally Posted by Golddog

Good suggestions - I've had success with most of the above. However, CCI aluminum-cased has NOT run reliably in any of the many pistols I've owned, including Glock 19's, a 26, and a 34.

Could be the lot, the last case of CCI blazer 115gr I used felt underpowered and would not cycle my slide properly. However, this case was shot towards the back end of 10,000 rounds with an old recoil spring and weak mag springs. A call to LWD and Glockmeister fixed that problem. Nevertheless, Blazer is as clean as it gets.

Right now, I'm rocking 124gr TMJ Speer Lawman. Hot stuff, but dirty as heck!

gman67

[JimIsland]

I have put 800 rounds of WWB through my G26 and over 1000 rounds through my 380 Bersa without a glitch. It's cheap and readily available. I heard from a few peeps that it was low grade, crap ammo but since I haven't had a single FTF or FTE, "I" have to disagree.

[jeffyjeff]

wwb 100 round boxes. every single box has 101-103 rounds in it, it's like getting a present!

[IT0]

Originally Posted by Adjuster

Good ole Winchester White Box. Or anything else they sell at WalMart.

Ditto

[tcruse]

Originally Posted by Golddog

Good suggestions - I've had success with most of the above. However, CCI aluminum-cased has NOT run reliably in any of the many pistols I've owned, including Glock 19's, a 26, and a 34.

The cci aluminum sold under the Blazer box is not the hottest ammo, I have however not had any issues with it. I have shot it with Springfield XDm, Glock 26 Gen3, Glock 17 Gen4, Ruger P95 and Keltec P11. The TNJ version from Cabelas is even cleaner and maybe hotter than the other. Have not done any measurements. Rated at 1150 fps. I have read several reports of engineering tests that show the aluminum case is many times stronger than the brass case. If you re-load then brass is better, but otherwise the aluminum may be a better choice.

If anyone has documentation on the subject please pass it on.