S&W M60 fired cases stick
Model 60 , .357 - I've always had issues with this gun dropping fired .38 spl cases out. They always seemed to catch right at the case mouth. Now that I've started reloading for .357 also, I've found that reloaded ammo has a harder time going in and the first batch of (relatively light) .357 I could NOT extract by hand, I had to take a dowel to them to get them out. This is not an issue on my Model 65, even with the same loads. Did S&W make these with tighter tolerances in the chambers?
I've looked at polishing the chambers, but they really don't look very rough. Any other ideas?
Also, anyone have an opinion on the WC spring kits for these from MidwayUSA?
Cruisers and Glocks, and not enough cash for either!