Thread: CETME Problems
View Single Post
Old 01-30-2013, 15:04   #4
countrygun
Senior Member
 
Join Date: Mar 2012
Posts: 17,068
Quote:
Originally Posted by grit usmc View Post
thats one thing im trying to find is what the head spacing is normally set at and how to check/adjust it if its not right. do you know any good resources

thanks
grit
Best thing I can say is to prowl the internet forums I got a lot of info back then but when I got rid of the gun I didn't keep up with the sites.

There was quite a bit of info around about how the assemblers had cheated on the headspace with apparently a Dremel.
countrygun is offline   Reply With Quote