View Single Post
Old 01-29-2013, 18:04   #15
SuckMyGlockk
Member
 
SuckMyGlockk's Avatar
 
Join Date: Jan 2013
Posts: 23
Quote:
Originally Posted by cciman View Post
Use a sight tool as mentioned previously.

came in the mail, what i used was a hammer and a piece a wooden steel brush handle and it took the plastic one straight out and put the steel right in. did in on the side of duck tape, saved myself 50 bucks of having the dealer do it, and 100 bucks for teh sight installation tool. just measured the slides exposed surface one each side of the sight by eye and it looks pretty good. will do some fine tuning next time im at the range. thanks for all your input. did NOT use loctite. there is no way it is necesarry.
SuckMyGlockk is offline   Reply With Quote