View Single Post
Old 01-24-2013, 12:21   #1
Fwdftw
Senior Member
 
Fwdftw's Avatar
 
Join Date: Apr 2009
Location: Hernando MS
Posts: 2,524
Hypothetically Speaking.

If i installed my dynacomp in a vice with shop towels holding it in there.. AND JUST SAY i hypotehtically gouged the barrel a little with a scratch.. How would one repair this? The person that did this doesnt care as its a shooter and not a wall hanger.. How would he prevent rust etc? High heat paint? The same he put on his gas block when he cut it down to make it Lo Pro? Just looking for advice.. it certainly wasnt me that did this

Picture
Black Rifle Forum

Last edited by Fwdftw; 01-24-2013 at 14:15..
Fwdftw is offline   Reply With Quote