View Single Post
Old 01-22-2013, 10:23   #47
fredj338
Senior Member
 
fredj338's Avatar
 
Join Date: Dec 2004
Location: so.cal.
Posts: 21,653
Blog Entries: 3
Quote:
Originally Posted by HunterLee View Post
If it was a squib, the slide would have to been manually racked and then shot. I don't think squib, though it would be hard to double charge on an autoindexing press I guess anything is possible.
This is the problem. Too many assume too much. You can get a squib & have the slide cycle if using light springs. You can have a powder issue on ANY progressive press, crap happens. It's why you have to be vigilant & not just be pulling the handle.
__________________
"Given adequate penetration, a larger diameter bullet will have an edge in wounding effectiveness. It will damage a blood vessel the smaller projectile barely misses. The larger permanent cavity may lead to faster blood loss. Although such an edge clearly exists, its significance cannot be quantified".
fredj338 is offline   Reply With Quote