View Single Post
Old 01-22-2013, 07:41   #45
45ACP223
Member
 
45ACP223's Avatar
 
Join Date: Jan 2013
Location: SE IN
Posts: 24
Quote:
Originally Posted by n2extrm View Post
I had an issue on my 650 with a couple of squibs.

Went over the machine and found the nut bolt that ran through the bel crank on the powder measure had loosened up. Just enough that the white plastic cube would jump out of the powder bar and back in again.

Just something to check. Of it now was a lock nice new nut on it with a dot of locktite for good measure.
That's interesting, I've loaded thousands of rounds with my Dillon Sq. Deal and never had any mechanical problems until last week. I had the same issue you did with the bolt coming loose on the bell crank. I ended up weighing that lot of 50 bullets and found one without powder. I guess that bolt loosening is a common problem with Dillons to watch out for.
__________________
NRA Life Member
INGO Member
NMLRA Member
45ACP223 is offline   Reply With Quote