View Single Post
Old 01-11-2013, 11:53   #37
Brian Lee
Drop those nuts
 
Brian Lee's Avatar
 
Join Date: Jul 2008
Location: Up a tree.
Posts: 7,710
I'm so unimpressed with Taurus that I find it hard to waste another moment writing any further about them. Except to say that I think they do some of the sloppiest loose-tolerance machining I've ever seen on gun parts. The last Taurus revolver I held in my hands simply would not lock up worth a crap when cocked. You could rotate the cylinder about .040" from either side of the proper lock-up position.

Somehow I think the chambers should be held in line with the barrel a lot better than that.
Brian Lee is offline   Reply With Quote