Thread: .44spl
View Single Post
Old 01-10-2013, 19:06   #35
fredj338
Senior Member
 
fredj338's Avatar
 
Join Date: Dec 2004
Location: so.cal.
Posts: 21,651
Blog Entries: 3
Quote:
Originally Posted by BuckyP View Post
Since I already own an XL650, I can't see using a single stage press at this point (even though I have one).

It's doable if you're creative.
I load on a 550 & 650, but still use my ss press a lot. If I want to put together 50rds of 44mag, I don't tear down my 550 for that, just use the ss press. My point was if it was the only gun I had, it would be worth buiying a ss kit to reload for it. Factory 44mags are quite expensive. Most 44mag shooters don't shoot them more than 100rds a week. You do NOT need a progressive for that volume.
__________________
"Given adequate penetration, a larger diameter bullet will have an edge in wounding effectiveness. It will damage a blood vessel the smaller projectile barely misses. The larger permanent cavity may lead to faster blood loss. Although such an edge clearly exists, its significance cannot be quantified".

Last edited by fredj338; 01-10-2013 at 19:10..
fredj338 is offline   Reply With Quote