View Single Post
Old 12-09-2012, 18:09   #260
Lone_Wolfe
CLM Number 226
Sandbox Refugee
 
Lone_Wolfe's Avatar
 
Join Date: Apr 2006
Location: This side of a tombstone
Posts: 27,364


Quote:
Originally Posted by Travclem View Post
I understand the trade off but 60-61 is not where the chipping will be bad. 62-64 probably will. I understand Chris does this to keep his collectors from *****ing about chipped edges, but I'd really like a knife that could field dress a deer and keep going. Just a few ribs is all it takes to roll CRK's s35 so bad it will no longer cut. My buck vanguard in 420hc handles it just fine, as do my Lusk customs in CPM154. Its pretty sad when a $70 Buck in 420hc is outperforming a $425 dollar CRK in S35vn. Not only outperforming it, flat out smoking it.

The whole reason CRK went to this steel was to save wear on tools, but in the end it is an inferior steel to S30V. For $425 you should at least get decent steel. S35vn could be an ok steel if Chris didn't leave it so soft. I carry my 'Zaan every day and have used it hard, the steel is just not good at all. I continue to carry it due to the excellent craftsmanship and fit, but I always carry a backup knife in good steel. Since I am a user more than a collector, I will never own another CRK in this steel.

In the spirit of the thread
The Cutting Edge
Nice knife!

I prefer the 30 myself, and have been grabbing them when I have a chance.
__________________
NRA Benefactor Member++++++SAF Life Member+++++++++++

To those who have made the ultimate sacrifice while defending American freedom, you will not be forgotten.

RIP my friends Greg and Florence, see you again on the other side.
To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures.

RIP Jeff (23Skidoo) - 1962-2012 and Gloria (Silent_Runner) - 1964-2013
FREEDOM IS NOT FREE
Lone_Wolfe is offline   Reply With Quote