View Single Post
Old 12-09-2012, 08:19   #258
Travclem
Lifetime Membership
Badass Member
 
Travclem's Avatar
 
Join Date: Aug 2008
Location: Lubbock, TX
Posts: 6,683
Quote:
Originally Posted by Lone_Wolfe View Post
Thanks. I stole that one.





Kind of a tradeoff. You get too hard, and the blade chips too easisy. You get to soft, and it rolls.
I understand the trade off but 60-61 is not where the chipping will be bad. 62-64 probably will. I understand Chris does this to keep his collectors from *****ing about chipped edges, but I'd really like a knife that could field dress a deer and keep going. Just a few ribs is all it takes to roll CRK's s35 so bad it will no longer cut. My buck vanguard in 420hc handles it just fine, as do my Lusk customs in CPM154. Its pretty sad when a $70 Buck in 420hc is outperforming a $425 dollar CRK in S35vn. Not only outperforming it, flat out smoking it.

The whole reason CRK went to this steel was to save wear on tools, but in the end it is an inferior steel to S30V. For $425 you should at least get decent steel. S35vn could be an ok steel if Chris didn't leave it so soft. I carry my 'Zaan every day and have used it hard, the steel is just not good at all. I continue to carry it due to the excellent craftsmanship and fit, but I always carry a backup knife in good steel. Since I am a user more than a collector, I will never own another CRK in this steel.

In the spirit of the thread
The Cutting Edge
__________________
Sent from a payphone in a whorehouse in Mexico.
__________________

Last edited by Travclem; 12-09-2012 at 08:23..
Travclem is offline   Reply With Quote